Business

How to block a washbasin

When the bathroom sink starts to sink slowly There is a high chance that the sink drain will lock in the sink line. There are a number of factors that can cause a zinc leak to clog. Excessive hair, dry toothpaste, and debris are just some of the causes of clogging. Before we look at the best ways to solve this problem. Let’s look at a few ways to avoid them first. Most bathroom sinks have partitions to prevent large items from DÉBOUCHAGE. When the homeowner opens these curtains will cause hair and other impurities to pass through and often clings to dirt Here’s a simple solution. That should flush your drain in a few minutes to resolve the issue.

1. Use industrial energy-draining cleaners. This is the easiest but least effective way to block drainage. In this way, you pour solid liquids into the sink and allow the liquid to drain slowly. This process can take anywhere from 30 minutes to several hours. It depends on the severity of the blockage and the strength of the wastewater treatment. This is a great way to try out a small blog and it can be done in a matter of minutes.

2. Remove and clean the trap. Under the sink, there is a U-trap connected to the drain. The U-trap connects to the sink’s drain and is usually the second drain hose that runs into the wall or floor. The U-trap is usually connected. with screws to both pipes It can be removed and removed from both sides. Before you do this After removing the U-trap, you can clean the trap with a wire hanger. Get ready for some unpleasant odors. Blocking the u-trap tends to smell strong. Once you’ve cleaned the u-trap, you can attach it back to both tubes with screws on each end of the thread.

to avoid throwing fingers Use a claw or needle with a nose claw to lower and remove items. when pulled out Try using a wooden spoon or broom tip turning the knife. You may need to spin back and forth. when you unhook the knife change rubber boots Turn the appliance on and press the relax button on the outside of the sink under the sink. Turn on the water and start draining if the water is a good drain. Otherwise, the drain pipe will close.

in the next step You still have to remove all the water from the pool. If you have a dishwasher Use a clamp or clamp to remove the hose. Boil water in a pot and pour it into the drain. Wait 10 minutes. Place the drain stopper on the other side. Fill the lock side with water and try to drain the plug. Scald water removes most clogs.

You can then try removing the blockage using a drainage method. But I avoid using it because if it doesn’t work. You will need to drain and spread the drains on your skin or eyes. A less toxic version of the septic solution can be mixed with baking soda and vinegar.

Drain the water. Mix 1/3 cup baking soda and 1/3 cup vinegar in a large bowl. (The water will break and begin to expand) and pour it into each drain. Then boil another pot and let it sit for 10 minutes water. Then pour boiling water and simmer for a few minutes and try again. hope it works Or you may need to remove the P-trap (U-shaped pipe under your sink) and block your pipe.

In order to destroy the P trap, you think you still need to remove all the water from your pool. Then I took everything from the cabinet under the sink. You need a working area and sprinklers. large bath towels Place a tub under the trap if your P-trap is plastic. You don’t need a key to remove the plastic nut. and if you use a towel to wipe It gets harder to grip and feels sharper. If this is a metal P-trap, you’ll need a bigger key. Remove the P-trap (drain) and clean it.

Read More: 12 Most Unique Tourist Places in Rajasthan

Related Articles

Back to top button